how to cut luxury vinyl plank flooring

Best answer


Use a utility knifeto cut halfway through your vinyl plank. Using the framing square to guide your blade, begin cutting along the marked line at a 45-degree angle. You should apply a moderate amount of pressure to cut roughly halfway through your vinyl plank.

People also ask


  • How to cut vinyl plank flooring without damaging it?

  • Use the tape measure to mark the board for the cut. Always use the backside of the vinyl plank flooring to keep pencil marks and the potential for damage to a minimum. This also helps protect the wear layer from damage with miter or table saws. Take the speed square to mark the cut line across the back of the board.

  • How do you stagger vinyl plank flooring?

  • They are made on planks as you complete a row and as you cut planks to stagger vinyl plank flooring. Step 1. Measure and mark the plank on the waste side of the cut line.

  • How do you cut a small piece off of a plank?

  • Step 1. Measure in from the side near both ends of the plank, and make a small mark where the cut will be made. Again, remember to make your mark on the scrap side of the plank, the piece to be trimmed away.

  • How do you cut a straight line on a floor plan?

  • Draw along the side of the framing square to give you a straight edge. Your line will be perpendicular to the edge of the plank you won鈥檛 be cutting. You can also mark the position of your cut by placing the plank on the floor. Then draw a line where the previous plank finishes.

    Leave a Comment