how to cut luxury vinyl plank flooring

Best answer


A simple,sharp cutter knife, a pen, and a cutting rail or angleare enough to cut a vinyl floor from the vinyl sheet. To do this, simply mark the cut edge with a pen and cut the surface of the vinyl floor with the cutter. The rail ensures that both the marking and the cut are straight and at the correct angle.

People also ask


  • How to cut vinyl plank flooring without damaging it?

  • Use the tape measure to mark the board for the cut. Always use the backside of the vinyl plank flooring to keep pencil marks and the potential for damage to a minimum. This also helps protect the wear layer from damage with miter or table saws. Take the speed square to mark the cut line across the back of the board.

  • How do you stagger vinyl plank flooring?

  • They are made on planks as you complete a row and as you cut planks to stagger vinyl plank flooring. Step 1. Measure and mark the plank on the waste side of the cut line.

  • How do you cut a small piece off of a plank?

  • Step 1. Measure in from the side near both ends of the plank, and make a small mark where the cut will be made. Again, remember to make your mark on the scrap side of the plank, the piece to be trimmed away.

  • How do you lay vinyl planks on a wall?

  • Once you鈥檝e cut the tongues, you should lay the first row with the cut side facing the wall. Also, carefully place the vinyl planks to keep an even expansion gap between them and the wall. Your first plank is down.

    Leave a Comment